Smart Panel Firmware

Update process

Note!
The Smart Panel with firmware version 6.08.01 works only with CLU not older then CLU Z-Wave firmware version 5.08.01-2128B (or higher) and application Object Manager version 1.7.0-2248 (or higher).

Note!
Before Smart Panel firmware update please update CLU Z-Wave firmware and interfaces database first. Update steps:
- CLU Z-Wave firmware update.
- Updating and reloading the XML interfaces database.
- Updating the Smart Panel firmware (according to the Smart Panel update procedure below).
- Execution of CLU Discovery.

Smart Panel firmware update via SD card:

Disconnect the Grenton Smart Panel from the power supply.
Download the .zip file and extract it.
Remove the microSD card from the Smart Panel memory slot according to the procedure presented in the manual or in the data sheet.
Paste the downloaded (unpacked) files onto the memory card, overwriting the existing ones.
Put the memory card back into the slot.
Connect the power supply to the Grenton Smart Panel module.
After powering and detecting a newer firmware version, the module will start the update procedure.
The software update process is signaled by alternating flashing of the upper diodes.
Correct completion of the update is confirmed by several blinks of all LEDs green.
In case of failure of the update process, the whole procedure should be repeated.

In case of constant failures while firmware update please contact with the Grenton Technical Support.